La Crosse Technology Weather Radio 9245 User Manual

LCD SCREEN AND SETTINGS  
This limited warranty begins on the original date of purchase, is valid only on products purchased  
and used in North America and only to the original purchaser of this product. To receive warranty  
service, the purchaser must contact La Crosse Technology, Ltd for problem determination and  
service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd  
authorized service center. The original dated bill of sale must be presented upon request as  
proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized  
service center.  
Time  
Low Battery  
indicator (temp station)  
Indoor Temperature in °F  
Wireless Temperature Station  
La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as  
stipulated herein, with new or reconditioned parts or products if found to be defective during the  
limited warranty period specified above. All replaced parts and products become the property of  
La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement  
parts and products assume the remaining original warranty, or ninety (90) days, whichever is  
longer. La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs  
covered by this warranty. If necessary repairs are not covered by this warranty, or if a product is  
examined which is not in need or repair, you will be charged for the repairs or examination. The  
owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product  
to a La Crosse Technology, Ltd authorized service center. La Crosse Technology, Ltd will pay  
ground return shipping charges to the owner of the product to a USA address only.  
MIN/MAX Indoor temperature  
Outdoor Reception Signal icon  
Low Battery indicator (transmitter)  
Outdoor Temp in °F  
Model 9245  
Quick Setup Guide  
MIN/MAX Outdoor temperature  
Minutes (flashing)  
Hanging hole  
MANUAL TIME SET  
To manually set the time of the Temperature Station:  
Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with  
the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect  
(including the lack of reasonable and necessary maintenance); (2) damage occurring during  
shipment (claims must be presented to the carrier); (3) damage to, or deterioration of, any  
accessory or decorative surface; (4) damage resulting from failure to follow instructions contained  
in your owner’s manual; (5) damage resulting from the performance of repairs or alterations by  
someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units  
used for other than home use (7) applications and uses that this product was not intended or (8)  
the products inability to receive a signal due to any source of interference. This warranty covers  
only actual defects within the product itself, and does not cover the cost of installation or removal  
from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the  
seller or performance variations resulting from installation-related circumstances.  
Battery  
compartment  
LCD display  
Hour (flashing)  
1.  
2.  
3.  
Press and hold the SET key for 3 seconds to enter the manual time setting mode.  
Function keys  
The hour digit of the time display will be flashing.  
Press the + key to adjust the hour (press and hold to allow fast advance). Press SET key  
to confirm and go to the minute setting.  
The minute digit will be flashing. Press the + key to adjust the minute (press and hold to  
allow fast advance). Press SET key once more to return to normal display.  
Stand  
4.  
FEATURES  
The Temperature Station  
Note: If no buttons are pressed within approximately 8 seconds while in setting mode, the unit  
Manual time set (hour and minute)  
12-Hour Time Format  
will return to normal operating mode.  
LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL,  
CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE  
OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED  
FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A  
TOY. KEEP OUT OF CHILDREN’S REACH.  
Temperature Display in Farenheit (°F)  
Indoor and Outdoor Temperature with MIN/MAX Records  
Low Battery Indicator  
Wireless Transmission at 915 MHz  
8 Second Signal Reception Interval  
Wall Mount or Table Stand  
VIEWING THE INDOOR TEMPERATURE AND MIN/MAX  
The indoor temperature is displayed in the second section of the LCD along with the indoor  
MIN/MAX records:  
Indoor temperature  
This warranty gives you specific legal rights. You may also have other rights specific to your  
State. Some States do not allow the exclusion of consequential or incidental damages therefore  
the above exclusion of limitation may not apply to you.  
The Outdoor Temperature Transmitter  
MIN indoor temperature  
MAX indoor temperature  
Wireless 915 MHz Outdoor Temperature Transmitter  
Rain-resistant Casing  
Wall Mounting or Table Stand  
Notes:  
For warranty work, technical support, or information contact:  
The minimum temperature range: 14ºF to 99ºF (100ºF to 140ºF will show “99ºF”).  
The maximum temperature range: 14ºF to 140ºF  
The MIN/MAX temperature resolution is 1ºF  
La Crosse Technology, Ltd  
2817 Losey Blvd. S  
La Crosse, WI 54601  
Note: Mount in a sheltered place. Avoid direct rain and sunshine.  
The resolution of the indoor temperature is 0.5ºF  
VIEWING THE OUTDOOR TEMPERATURE AND THE MIN/ MAX  
The outdoor temperature is displayed in the last section of the LCD along with the outdoor  
MIN/MAX records:  
SETUP  
FCC ID: OMO-TX40U (transmitter)  
FCC DISCLAIMER  
IMPORTANT: Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or  
rechargeable (nickel cadmium) batteries.  
RF Exposure mobile:  
Outdoor temperature  
The internal / external antennas used for this mobile transmitter must provide a separation distance of at  
least 20 cm (8 inches) from all persons and must not be co-located or operating in conjunction with any  
other antenna or transmitter."  
Note: This temperature station can only receive one transmitter only.  
MIN outdoor  
MAX outdoor temperature  
temperature  
1.  
2.  
First, insert batteries into the transmitter, observing the correct polarity (see marking inside  
battery compartment).  
Notes:  
Statement according to FCC part 15.19:  
Within 30 seconds of powering up the transmitter, insert batteries into the Temperature  
Station, observing the correct polarity (see marking inside battery compartment). Once the  
batteries are in place, all segments of the LCD will light up briefly. Following the indoor  
temperature, the time as 12:00 will be displayed. If they are not shown in the LCD after 60  
seconds, remove the batteries and wait for at least 60 seconds before reinserting them.  
Once the indoor data is displayed you may proceed to the next step.  
The MIN/MAX temperature resolution is 1ºF  
The resolution of the outdoor temperature is 0.2ºF  
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:  
(1) this device may not cause harmful interference, and (2) this device must accept any interference  
received, including interference that may cause undesired operation.  
TO RESET THE MIN/MAX DATA  
Statement according to FCC part 15.21:  
Modifications not expressly approved by this company could void the user's authority to operate the  
equipment.  
The MIN/MAX temperature can be reset manually by pressing and holding the + key for about 3  
seconds. This will reset all indoor and outdoor MIN/MAX temperature to current indoor and  
outdoor temperatures.  
3.  
4.  
After the batteries are inserted, the Temperature Station will start receiving outdoor temp  
data from the transmitter. The outdoor temperature should then be displayed on the  
Temperature station. If this does not happen after 2 minutes, remove the batteries from  
both units and start again from step 1.  
In order to ensure sufficient 915 MHz transmission, the outdoor transmitter should be  
placed a distance of no more than 200 feet (60 meters) from the Temperature Station and  
the transmitter (see notes on “Positioning”).  
Statement according to FCC part 15.105:  
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,  
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against  
harmful interference in a residential installation. This equipment generates, uses and can radiate radio  
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful  
interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation. If this equipment  
does cause harmful interference to radio or television reception, which can be determined by turning the  
equipment off and on, the user is encouraged to try to correct the interference by one or more of the  
following measures:  
POSITIONING THE REMOTE TEMPERATURE TRANSMITTER:  
The remote temperature transmitter can be placed onto any flat surface or wall mounted using  
the bracket which doubles as a stand or wall mount base.  
To wall mount: Secure the bracket onto a desired wall using the screws  
and plastic anchors.  
FUNCTION KEYS  
The Temperature Station has only two easy to use function keys:  
Clip the remote temperature transmitter onto the bracket.  
Note: The mounting surface can affect the transmission range. If, for  
instance, the unit is attached to a piece of metal, it may then either  
reduce or increase the transmitting range. For this reason, we  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to which the receiver is  
connected.  
SET key  
+ key  
recommend not to place the unit on any metal surfaces or in any  
position where a large metal or highly polished surface is in the immediate vicinity (garage doors,  
double glazing, etc.). Before securing in place, please ensure that the Temperature Station can  
receive the 915MHz signal from the temperature transmitter at the positions that you wish to  
place them.  
Consult the dealer or an experienced radio/TV technician for help.  
SET key:  
Press and hold for about 3 seconds to enter the Manual setting mode.  
All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed  
using electronic, mechanical or chemical procedures without written permission of the publisher.  
This handbook may contain mistakes and printing errors. The information in this handbook is regularly checked and  
corrections made in the next issue. We accept no liability for technical mistakes or printing errors, or their  
consequences.  
+ key:  
Press to make adjustment in the setting mode. Press and hold to reset all MIN/MAX  
records  
WARRANTY  
La Crosse Technology, Ltd provides a 1-year limited warranty on this product against  
manufacturing defects in materials and workmanship.  
EJMA9245L220#  
All trademarks and patents are acknowledged.  
Printed in China  
 

Lantronix Network Card 900 685 User Manual
Lexar Media MP3 Player LDP 600 User Manual
LG Electronics Car Video System 19MB35P User Manual
Life Fitness Elliptical Trainer Rear Drive Cross Trainer User Manual
Lincoln Electric Welding System IM795 User Manual
Logitech Speaker System Z523 User Manual
Makita Saw 4305T User Manual
Martin Audio Network Card CMX2A User Manual
Maytag Washer MFW9800TK0 User Manual
Mercury Marine Boat 899194001 User Manual