Freedom Walker
Item 80500
Contents:
(1) Partially assembled walker frame, outriggers,
adjustable seat and gate
(1) PVC back section with mesh vinyl backrest sling
(4) Four caster wheels (2 braking / 2 non-braking)
(2) Two each parallel arms
(4) Four safety wire lock pins, pins are to secure the
adjustable height section
(1) Adjustable safety belt
(14) Fourteen (14) each ½" stainless steel screws
(2 each for the back section, 4 each for the
caster section, 8 each for the out-riggers)
(6) Six each 1" stainless steel screws (4 each for the
adjustable arm section, 2 each for the swing gate)
Assembly Instructions:
Step 1
Remove partially assembled walker from shipping container/box.
Step 2
Caster Assembly and Outriggers:
1. Install one caster into each of the female fittings on the bottom frame section.
2. Secure each caster by inserting one ½" screw into the pre-drill pilot hole on the
female fitting and tighten with a Phillips screwdriver.
3. Insert the outrigger into each side of the walker next to the casters. The front section
of the outrigger (three way fitting) must connect into the front section (four way
fitting on the frame). Secure the outrigger with one ½" stainless steel screw. Insert the
vertical support legs into the outrigger (4 each of leg piping). Secure each vertical
support leg with one ½" stainless steel screw.
Step 3
Adjustable Seat:
1. Align bottom of the seat section fittings with the top of the 1" PVC pipe that extends
out from the lower base near the casters. Slide the 1" PVC pipe vertically into the seat
section until the last vertical adjustable hole is exposed. The four safety wire lock pins
fit into each fitting that accommodates the 1" PVC pipe. The (T) fittings and the four
(FOUR WAY) fitting takes 1 safety wire lock pin to secure the 1" PVC pipe from moving.
2. Connect the seat section with the bottom half of the 1" PVC pipe. The 1" PVC pipe
needs to be secure with the fittings located above the casters.
3. Secure the 1" PVC pipe and with 1 each of the 1" stainless steel screws.
80500-INS-LABRevA06
|