Marshall electronic Computer Monitor V R72P 2C User Manual

Marshall  
V-R72P-2C Instruction Sheet  
Broadcast Multimedia Division  
The V-R72P-2C is a rack mountable unit that has two 7” 16:9 active matrix LCD panels with NTSC/PAL auto  
recognition. These panels have 1440 x 234 pixels making them a true high resolution LCD panel. The unit  
offers 2 composite video inputs per panel with loop through capability. The unit fits into an EIA standard 19”  
rack, 3U high. Each of the screens can switch between 16:9 and 4:3 aspect ratios and has a built-in color  
bar generator, individual front mounted selector buttons with LED’s and color, tint, brightness and contrast  
controls. Unit comes with power supply and instructions.  
The operation of the V-R72P-2C is fairly straightforward, however, please take note of the following:  
1. The V-R72P-2C has been designed to fit in a 3U space on your rack.It may be necessary to center the unit  
up or down in order to not touch any adjacent units in your rack when tilting unit up or down. The auto signal  
detection will display a blue screen with the absence of a signal. The V-R72P-2C has a memory function that  
will remember the settings of each monitor including power and channel selection even if power has been dis-  
connected from the unit.  
2. Each LCD Panel comes with a protective plastic film that must be removed by carefully lifting the film from  
the corner and peeling it off. Be certain not to apply any pressure on the LCD panels, they are fragile and can  
break. Scratched, cracked or broken LCD screens are not covered by our warranty.  
3. The V-R72P-2C uses 12VDC, 3.0amp regulated power. Be certain that these specifications are met when  
using a power supply other than the one supplied to you by Marshall Electronics. The center pin on the coaxial  
power connector for the V-R72P-2C is the POSITIVE terminal and the outside ring is NEGATIVE. Any battery  
operation of the V-R72P-2C must have this polarity configuration.  
4. The Video inputs on the rear of the panel are 75 Ohm self-terminated. The loopthrough feature uses active  
components and is always active as long as power is supplied to the unit regardless of the monitor being On or  
Off.  
2.5”  
Rear View  
Side View  
Power  
Consumption  
Picture  
Elements  
Display  
Viewing Area  
Dot Pitch  
Inputs  
Color Bars  
Dimensions  
7” LCD  
Active Matrix each panel  
6.07” x 3.41” 0.108mm x  
19.125W x  
5.14H x 3.75D  
12 VDC  
3.0 Amps  
2 NTSC/PAL  
inputs per panel  
Built into unit  
1440H x 234V  
0.375mm  
 

Lenovo Personal Computer 0B39663 User Manual
LG Electronics Microwave Oven LMV1635SB User Manual
Logitech Webcam C250 User Manual
LOREX Technology Security Camera SG7555RPK4 User Manual
Mackie Stereo Amplifier UP4061 User Manual
Magic Chef Microwave Oven MCM1110ST User Manual
Magnavox Clock Radio AJ3282 User Manual
Magnavox CRT Television MPF68A MTV68A User Manual
Makita Impact Driver 6980FD User Manual
Metz Camera Flash 28 CS 2 User Manual