Gas Dryer
PRODUCT MODEL NUMBERS
MGD3000B, MGD4000B, MGD4200B,
MGD6000A, MGD7000A, MGD8000A
DRYER DIMENSIONS
Front view:
Side view:
27"
(686 mm)
383/4" Min.
(984 mm)
39" Max.
(990 mm)
Back view:
61/4"
(159 mm)
* Approx. measurement
Recommended installation clearances (dryer only):
297/8"*
(759 mm)
Water inlet
(Steam Models Only)
53/4"*
(146 mm)
31/2"*
(89 mm)
Vent
3"
(76 mm)
18" min.
(457 mm)
48 in.2 min.
(310 cm2)
Gas
61/8"*
3/4"*
(18 mm)
(156 mm)
143/8"
(365 mm)
24 in.2 min.
(155 cm2)
253/4"
*
5"
(654 mm)
3"
(76 mm)
* Approx. measurement
(127 mm)
NOTE: Most installations require a minimum of 5" (127 mm)
clearance behind dryer for exhaust vent with elbow. See “Venting
Requirements.”
1"
(25 mm)
1"
*
(25 mm)
* 0" (0 mm) spacing is allowed.
Installation spacing for recessed area
or closet installation
All dimensions show recommended and minimum spacing allowed.
■
Additional spacing should be considered for ease of
installation and servicing.
■
■
Additional clearances might be required for wall, door, floor moldings, dryer venting, and gas line.
Additional spacing should be considered on all sides
of the dryer to reduce noise transfer.
■
■
For closet installation, with a door, minimum ventilation openings in the top and bottom of the door
are required. Louvered doors with equivalent ventilation openings are acceptable.
W10573707B
10/2013
Companion appliance spacing should also be considered.
|